BCS Implements - Mini Round Hay Baler my goodness!
Retratable Internal External Screw Cutting Tool Videos by thehomeengineer - Hi AllFinally cut some threads with the retractable tool I have been working on for the last month or so. There are two videos one cutting an internal thread (M16x2) and the other cutting an external thread (M8x1.25). (This second video also shows my back stop being used) Overall, I am pleased with design and the first cut threads, with only a few minor tweaks to the design needed to improve it.(I am sure there will
Rotary Table/Deving Head by Nick Jonkman - I have designed and built this useful rotary table/dividing head that is very simple to use. No sector arm or plates to worry about. It uses a 30 to 1 worm gear ratio. It also uses a disc with 100 divisions for counter. I use one with a turn counter but a plain disc works just a well. You divide the number of divisions into 30 with a calculator. Set your dial at 0. If your answer was 2.1 you would turn your dial 2 revolution and the continue to stop…
Torch Adjustable Plate Bevel Attachment by oldtimer - I made this adjustable plate beveling attachment to cut bevels 30 to 60 degrees. Works great with my Victor 2460 torch but can be used with any torch.
Sherline 2000 Mill Accessory Plate for Tooling by jjr2001 - Well the little Sherline needed a place to keep all the accessories so I made the DROmounting bar longer and added a mounting pillar for a polycarbonate plate. The platehas a three thickness block on the upper right side. This is to keep bits like center drillsfrom falling through the plate. Extra holes for new accessories are in place. Many arejust .125
Quick to Load and Set Lathe Spindle Back Stop by thehomeengineer - Hi AllEasy to use lathe spindle backstop.Hi AllThis is a back stop I made for my Colchester Student 1800 lathe. The stop is machined with a piece of square stock clamped it one end with a counter sunk screw and a through thread at the other end. (like a key in a key way slot) The main body is then turned to the correct dimension to give a slide fit into the lathes head stock spindle. The square stock has the same outer dia